This is a bugfix release.

This is a maintenance release.

This release contains the following updates and fixes:
 

Common NORSAR Software Suite functionality

SEGY Property import, SEGY Seismic import

• Added option to specify a valid data range for property values also for (velocities and density) (New)
• Importing large cubes (typically 2GB+) sometimes led to write failure when storing the NSS cube, especially on Windows. Now more robust writing.
• On importing non-standard property types, the property type name was blanked out. Fixed now

VSP Survey generator

• Fixed limitation in line length for shot grid surveys

Workflows – general

• Fixes on archiving
• Recovering workflows using the tracer would eventually lead to only one tracer job being run

Model Builder

• Remove value-range in property functions: Now the values in the range are replaced by no-values, not a default, valid constant value.
• Property functions and interfaces can now be stored and removed .
• Clipping of interfaces by polygons is improved.
• Block relations for multi-z-valued interfaces are shown and can be set. “+” and “-“ replaces “Above” and “Below” for this type of interfaces.
• To support the “+” and “-“ specifications, the hot cursor information includes plot of the positive interface unit normal.
• Fixed to make attenuation and Thomsen property functions by interpolation.
• Fixed to load model with non-VTI anisotropy axis of symmetry.
• Removed some unnecessary warnings when a model is checked for validity.
• Minor fixes of user interface details.
   

MDesign functionality

• Sensors can be set enabled/disabled directly in the workflow setup
• Unit can be changed for Location Uncertainty results
• Sensor files can be used in the NORSAR-3D Traveltime Cube Generator workflow

This is a bugfix release which addresses an issue where in a certain situation the project could become corrupted.

This is a maintance release for MDesign.

This is the first maintenance release for MDesign.