This release contains the following updates and fixes:
 

Common NORSAR Software Suite functionality

SEGY Property import, SEGY Seismic import

  • Added option to specify a valid data range for property values also for (velocities and density) (New)
  • Importing large cubes (typically 2GB+) sometimes led to write failure when storing the NSS cube, especially on Windows. Now more robust writing.
  • On importing non-standard property types, the property type name was blanked out. Fixed now

VSP Survey generator

  • Fixed limitation in line length for shot grid surveys

Workflows – general

  • Fixes on archiving
  • Recovering workflows using the tracer would eventually lead to only one tracer job being run

Model Builder

  • Remove value-range in property functions: Now the values in the range are replaced by no-values, not a default, valid constant value.
  • Property functions and interfaces can now be stored and removed .
  • Clipping of interfaces by polygons is improved.
  • Block relations for multi-z-valued interfaces are shown and can be set. “+” and “-“ replaces “Above” and “Below” for this type of interfaces.
  • To support the “+” and “-“ specifications, the hot cursor information includes plot of the positive interface unit normal.
  • Fixed to make attenuation and Thomsen property functions by interpolation.
  • Fixed to load model with non-VTI anisotropy axis of symmetry.
  • Removed some unnecessary warnings when a model is checked for validity.
  • Minor fixes of user interface details.
     

MDesign functionality

  • Sensors can be set enabled/disabled directly in the workflow setup
  • Unit can be changed for Location Uncertainty results
  • Sensor files can be used in the NORSAR-3D Traveltime Cube Generator workflow